Using Packet tracer, write a report on Cisco commands to set up the following network: - 2 PCs (PC1 & PC2) are connected to a Switch A. - 2 PCs (PC3 & PC4) are connected to Switch B. - 1 Server is connected to a Hub. - Switch A is connected to Router (R1) through Fast Ethernet interface. - Switch B is connected to Router (R2) through Fast Ethernet interface. - The Hub is connected to Router (R3) through Fast Ethernet interface. - The three routers are connected to each other through serial interfaces. - 1 PC (PC0) is used as a console and connected to R1 console port. - Assign an IP address to each of the PCs, and routers' interfaces. a. Answer the following questions: i. How many Broadcast domains, and how many collision domains are in this network? ii. What type of cables are used between the following devices: 1. PC1 and Switch A. 2. The Hub and R3. 3. PC0 and R1. b. From PC0, go to Desktop tab, and then choose Terminal to access R1 through the console port. From R1 prompt, ping all other PCs to check connectivity with each of them. c. For each of the routers and switches, configure the following parameters: i. Hostname. ii. Description to all routers interfaces. iii. All passwords (Enable, Secret, Console, Aux and vty).