i ordered 1 assignment few days before. its 2nd part of that assignment. so i want to link it with that one and if possible with that person who made my previous order. With reference EM201742NIT42MIS .Assignment Requirements and Report structure details FOR ASSIGNMENT 2: As the consultant, your brief is to advise your clients on the possibilities that would best suit their requirements. You do this by writing a non-technical report that addresses the questions raised in the Case Study Questions and making full use of the references you identified in assignment 1 plus four more scholarly references, making a minimum total of ten references. Note that your use of the references should fully incorporate any feedback received from assignment 1 assessment. For example, if a reference was marked as inappropriate in assignment 1, then that reference cannot be used in assignment 2. You must select a new reference to replace the inappropriate one. Assignment 1 will not be marked again so do not re-submit it – the replacement reference(s) will be marked on its merits in assignment 2 with no further opportunity to change it. The four additional references required in assignment 2 must be scholarly references only, and must be selected to support your discussion in the same manner as those selected in the first assignment. You may use more references if you wish to do so, provided they are appropriate and appropriately used. Use appropriate headings in your report, but do not present your discussion in question/answer format. Case Study – Education In Australia Page 2 of 2 As stated in the first assignment, some websites are not acceptable as reference sources. These include general encyclopaedic sites such as Wikipedia, and the numerous student study sites that publish papers in various school or university study categories. Notes: ? The assignment will be marked on the criteria listed in the marking guides that can be found on the course website. Use these marking guides to ensure that you haven’t forgotten anything. ? Do not discuss hardware and software specifications, such as memory or response times etc. Remember you must focus on addressing the concerns of management as detailed in the Case Study Questions, in a way that is understandable by non-technical managers. ? Make any assumptions that you find necessary; however, be sure to state your assumptions within the report. ? There is no fixed “correct” solution for the report. It is possible for students to make different recommendations. What is crucial is that the argument presented is logical and consistent, and clearly addresses the questions that were raised. ? The work submitted must be in your own words. Lengthy quotes, even if referenced correctly, are not considered to be your own work. Direct quotes should not form more than 40% of the report. In Assignment 2, you will write a non-technical report in which you provide answers to the Case Study Questions in detail. You will use the references chosen previously, adjusted appropriately according to assessment feedback if applicable. You must submit your report in the prescribed format .i also provided you a example of this assignment.so please go through all the instructions again and please confirm if you can do good work for me please.thanks