- 1 -
MACKAY REGIONAL COUNCIL
ADDENDUM TO REQUEST FOR TENDER
REQUEST FOR TENDER.: MRC 2017-025 ADDENDUM NO.: 1 DATE OF ISSUE: 3/02/2017 NO. OF PAGES: 2 plus 1 attachment
IMPORTANT : Please acknowledge receipt of this Addendum in writing within 48 hours of receipt. Facsimile acknowledgment may be made if the Respondent has registered on Qtender prior to receipt of this Addendum.
To: Attention: Jessica Marchant PO Box 41, MACKAY QLD 4740 [PH: 07 4961 9818 and FACSIMILE NUMBER 07 4944 2484] [email protected]
We acknowledge receipt of Addendum No. 1 to the Request for Tender for:
MRC 2017-025 Quota Park Shared Footpath
Name of Respondent
Address of Respondent
Signature
Date
- 2 -
This Addendum provides:
Mackay Regional Council wishes to advise the following: 1.Question: Will stage 1 and 2 be awarded as separate contracts? Answer: No, it will be awarded as one contract. Schedules are only separated due to State funding.
2.Question: Please supply annexure MRTS14A.1 as this has not been included in Tender documents Answer: Please find attached Annexure MRS14A.1
Department of Transport and Main Roads MRS14A.1 Specification Road Furniture (Steel Work) – Annexure
Page 1 of 2 MRS14A.1 April 11
Annexure MRS14A.1 Road Furniture (Steel Work) Specific Contract Requirements Contract Number MRC 2017-025 Note: Clause references within brackets in this Annexure refer to Clauses in the parent Specification MRS14A unless otherwise noted.
1 REGULATORY, WARNING AND HAZARD SIGNS 1.1 Method of Measurement for Supply (Clause 2.3.1) The supply of regulatory, warning and hazard signs shall be measured by Method A (lump sum)
Method B (each by sign type)
1.2 Method of Measurement for Installation (Clause 2.3.2)
The installation of regulatory, warning and hazard signs shall be measured by
Method A (lump sum) Method B (each by number of posts)
1.3 List of Regulatory, Warning and Hazard Signs (Method A only) (Table 2.1, Clauses 2.3.1 and 2.3.2) The following is a list of the regulatory, warning and hazard signs required under the Contract.
Sign Number Sign Type Size Quantity
R8-2B Shared Path 450X600 5 W6-9B Bicycles, Pedestrians 750X750 2
W8-23B Crossing Arrows 750X250 2 Total No. of Short Posts 0 Total No. of Long Posts 5
MRS14A.1 Department of Transport and Main Roads Road Furniture (Steel Work) – Annexure Specification
Page 2 of 2 MRS14A.1 April 11
2 DIRECTION AND INFORMATION SIGNS 2.1 Method of Measurement for Supply (Clause 2.3.3) The supply of direction and information signs shall be measured by Method A (lump sum)
Method B (square metres) 2.2 Method of Measurement for Installation (Clause 2.3.4) The installation of direction and information signs shall be measured by Method A (lump sum) Method B (each by sign number)
Method C (each by sign size)
2.3 List of Direction and Information Signs (Table 2.1, Clause 2.3.3 and Clause 2.3.4) The following is a list of the direction and information signs required under the Contract.
3 GRIDS (Clause 2.3.5) Item numbers for grids shall apply in the locations stated below. The required details of each grid shall be as stated in Clause 4 of Annexure MRTS14.1.
Item Number Reference Location N/A